Mack MP8 Diesel Engine Service Manual

Mack MP8 Diesel Engine Service Manual

description: The information in this manual is not all inclusive and cannot take into
account all unique situations. Note that some illustrations are typical and
may not reflect the exact arrangement of every component installed on a
specific chassis.
The information, specifications, and illustrations in this publication are
based on information that was current at the time of publication. Note that
illustrations and instructions are based on information that is subject to
change as new engine/chassis development continues.
No part of this publication may be reproduced, stored in a retrieval
system, or be transmitted in any form by any means including (but not
limited to) electronic, mechanical, photocopying, recording, or otherwise
without prior written permission of Mack Trucks, Inc.

Covers:Mack MP8 Diesel Engine
Size: 39mb
Language: English
Type: pdf
Pages: 342

Table of Contents

INTRODUCTION
SAFETY INFORMATION
EXPLANATION OF NUMERICAL CODE
CONVERSION CHART
ABOUT THE MACK MP7 ENGINE
VISUAL IDENTIFICATION
MP7 ENGINE MODEL IDENTIFICATION
DESCRIPTION AND OPERATION
MP7 ENGINE DESIGN FEATURES
GLOSSARY OF TERMS
COMPONENT LOCATOR
MP7 ENGINE COMPONENT LOCATION VIEWS
TROUBLESHOOTING
ENGINE SYMPTOM DIAGNOSIS
ENGINE CHECKS AND TESTS
MAINTENANCE
LUBRICATION SYSTEM MAINTENANCE
FUEL FILTER REPLACEMENT
COOLING SYSTEM MAINTENANCE
EXHAUST AFTERTREATMENT SYSTEM MAINTENANCE
DRIVE BELT REPLACEMENT AND TENSIONING
REPAIR INSTRUCTIONS, PART 1
ENGINE REMOVAL
ENGINE DISASSEMBLY
CYLINDER BLOCK RECONDITIONING
FLYWHEEL BENCH PROCEDURES
CONNECTING ROD AND PISTON BENCH PROCEDURES
CYLINDER HEAD OVERHAUL
ROCKER ARM SHAFT BENCH PROCEDURES
CAMSHAFT BENCH PROCEDURES
COOLING SYSTEM COMPONENTS BENCH PROCEDURES
ENGINE REASSEMBLY
ENGINE INSTALLATION
REPAIR INSTRUCTIONS, PART 2
IN-CHASSIS PART / COMPONENT PROCEDURES
OIL PUMP REPLACEMENT (IN CHASSIS)
CRANKCASE VENTILATION (CCV) SEPARATOR REPLACEMENT
TURBOCHARGER SMART REMOTE ACTUATOR (SRA) REPLACEMENT
UNIT INJECTOR CLEANING
INJECTOR COPPER SLEEVE REPLACEMENT
VALVE STEM HEIGHT MEASUREMENT PROCEDURE
VALVE STEM SEAL REPLACEMENT
REPAIR INSTRUCTIONS, PART 3
MP7 ENGINE SETUP AND ADJUSTMENT
ENGINE FINAL PREPARATION AND OPERATIONAL CHECK
REBUILT ENGINE RUN-IN PROCEDURES
SPECIFICATIONS
MP7 ENGINE MECHANICAL SPECIFICATIONS
ENGINE GASKETS, LUBRICANTS AND SEALANTS
SPECIAL TOOLS & EQUIPMENT
INDEX

Leave a Reply